A furnace that won't light or keeps shutting off needs real diagnosis, not another reset. A CO check happens on every call, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. Each gets tested with a multimeter and combustion analyzer, not replaced on a hunch, not parts-cannon guessing.
Safety and accuracy on every heating call.
Every repair includes a CO check, not optional.
We bump no-heat calls ahead of routine visits when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Both fuel types get the same trained tech, no exceptions.
The most common furnace failure points.
These two parts are behind most no-heat visits, usually a same-visit fix.
Gas valve testing confirms the fault before we recommend replacing it.
We inspect carefully with proper equipment rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older San Antonio furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Describe the symptom and we route the nearest tech and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Safety and diagnostic checks come first, then a flat-rate quote.
We re-check CO before signing off, backed by warranty.
Recent reviews from winter heating calls.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
Clicking without ignition often points to the ignitor, but we confirm with a resistance test before quoting.
It's a real safety concern, taken seriously.
A CO check is standard on every call, no upcharge.
We still service these older systems.
No-heat calls get priority routing, usually same-day even during high demand.
Uncommon parts might mean a follow-up visit to finish the repair.
Our furnace repair coverage spans San Antonio and nearby San Antonio, FL zips below — call to confirm.
Call +1-844-611-2875
